Warning: This module may not support sharing across sites


You are attempting to add a reference to this module that exists on another site in this group. This module may or may not support sharing across multiple sites - it doesn't explicitly state either way whether it does.

If you are sure that it does, or if your intent is to test its ability to do so, then proceed with caution and be aware that certain functionality in the module - or even the entire module - may not function correctly in this configuration.

If you are confused by this message or are working on a site that cannot tolerate any breakage, you should click Cancel and contact the DotNetNuke Support Team.


VICTOR 2.2D EDDY CURRENT FLAW DETECTOR FOR AUTOMATED INSPECTIONS

ETher NDE introduces the ViCTor 2.2D, the user-friendly automated eddy current inspection system, designed with the Automation Engineer in mind. 

Based on the ETher NDE AeroCheck+ Hardware, NDT Inspectors will become quickly familiar with its user interface and with a variety of case configurations available, the ViCTor 2.2D offers maximum flexibility for each individual application. 

CLIENT BENEFITS

Eddy Current is ideally suited to inspection automation particularly of so called rotationally symmetric components for the following reasons: 

  • NON-CONTACTING
  • HIGH SPEED (POTENTIALLY UP TO 200MS-1)
  • NO COUPLANT REQUIRED OR EFFLUENT PRODUCED
  • GOOD FOR SURFACE DEFECT DETECTION
  • INSTANT COUPLING
  • WIDE VARIETY AND GEOMETRY OF PROBES AVAILABLE
  • COST EFFECTIVE AND IDEAL FOR ROTATIONALLY SYMMETRICAL COMPONENTS E.G. BEARINGS, GUDGEON PINS, CYLINDER LINERS ETC.

CAPABLE OF USING TWO PROBES SIMULTANEOUSLY FOR MORE EFFICIENT INSPECTION. 

SEPARATE DUAL ALARMS. 

LARGE BRIGHT LCD SCREEN AND EXTERNAL VGA FOR MONITOR OUTPUT. 

INCLUDES ROTARY DRIVE AND CONDUCTIVITY. 

CONFIGURABLE I/O CAPABILITY USING VOLTAGE FREE CONTACTS. 

USB OR RS-232 REMOTE CONTROL. 

DUAL ANALOGUE OUTPUTS GIVING SIMPLE RECORDING. 

POWERED BY 24V DC FOR EASY INTEGRATION IN AN INDUSTRIAL CONTROL SYSTEM. 

RS-232 AND USB REMOTE CONTROL FOR EASY CONTROL SYSTEM INTEGRATION. 

ABILITY TO STREAM REAL TIME DATA OVER USB. 

A DLL IS AVAILABLE TO PERMIT SOFTWARE INTEGRATION BY THE END USER.